Syntax Serial port: MODE COMm: BAUDb PARITYp DATAd STOPs toonoff. Set your default terminal profile After installation, when you open Windows Terminal, it will start with the PowerShell command line as the default profile in the open tab. Select Startup and choose 'Windows Terminal' as the Default terminal application setting. Some of them are:Īll Loadstar Sensors' devices operate with the following settings: Configure a system device: COM / LPT port, or CMD console CON. Open Windows Terminal and go to the Settings UI window. In addition several free and/or open source serial port terminal programs are available for download on the internet. Hyperterminal is shipped with Windows XP (This can be found under ).If however you need to install the drivers on your own (you are using the device on a Linux or Mac, or writing your own software), then download and install the latest drivers the link above.Ī serial port terminal program is needed and can be used to communicate with the Loadstar Sensors' devices. The change port command maps a serial port to a different port number, allowing apps that dont support high-numbered COM ports to access the serial port. The various flavors of Loadstar Sensors' software, when installed, also install the above drivers needed for this communication. Most MS-DOS applications support only COM1 through COM4 serial ports. Download and install the latest drivers from (Scroll down to locate the appropriate drivers for your operating system.)Īll Loadstar Sensors' interface devices use an FTDI serial-port-to-USB device to communicate with the computer through a virtual serial port.
0 Comments
Leave a Reply. |